Frame design options

[Bee]

@chauhuh

It has been brought up a few times. It is a possibility. Great minds …

Musings on frame design

playing around with the simulator, there are a lot of different sources of errors, but the first one to try and address is the distance between the motors. An error of 2mm here can result in almost a 5mm error in the final cuts. We measure this by using the chain, which is FAR more accurate than trying to use a tape measure. However, this means that any flex in the frame that changes this distance i very significant. The stock frame depends on the plywood not warping, the arms not flexing, the…

I brought it up somewhere but can’t find it.

I vote you to be our first to complete a panel saw conversion

Thank you