Is it me, or is it Z?

[Tyler_W_Cox]

Used the same process / origin for Fusion 360 that I did for my first cut over here:

Cutting speed doesn't seem right

Thanks for all your help. I simplified the paths in the SVG, tweaked the image a little, and minified the file reducing the decimal precision. [alice2] I then dropped the tolerance in Fusion 360 to 0.1 inches which produced much less dense g-code. alice2.nc (725.6 KB) The final result cut in about 3 hours. [IMG_20180426_001843]

Only this time I used a more reasonable 0.015 inch tolerance rather than the .0004 mm tolerance that slowed down my first project.

I was hoping more G Code knowledge from 3d printing would transfer over to CAM. Unfortunately, it looks like I still have some learning ahead of me.