I’ll give this a shot! I finally got it going. I needed to go to line 7045 and it just would not go so I ended up pushing play at 0 and while it was moving to the first line I entered a random line with Go To and while it was moving to the random line of GCode I then entered 7045 and it worked! Not sure why but I was happy to finish the cut! I have also noticed that Go To holds the current z-axis height until there is a z-axis change in the code so you must first raise the z and then move to a line where there is the change before the actual line you want to go to. This was explained above but opening the file and looking thorough the lines helped me understand a bit better. Thanks for the tip!