do you need help finding the file for printing it?
Hai bisogno di aiuto per trovare il file per stamparlo?
1 Like
Here is the link. Nylon is good.
Ecco il link. Il nylon è ottimo.
ISO-10303-21;
HEADER;
/* Generated by software containing ST-Developer
* from STEP Tools, Inc. (www.steptools.com)
*/
/* OPTION: using custom renumber hook */
FILE_DESCRIPTION(
/* description */ ('STEP AP242',
'CAx-IF Rec.Pracs.---Representation and Presentation of Product Manufa
cturing Information (PMI)---4.0---2014-10-13',
'CAx-IF Rec.Pracs.---3D Tessellated Geometry---0.4---2014-09-14','2;1'),
/* implementation_level */ '2;1');
FILE_NAME(
/* name */ '6618555e6b66f90eb68493dd',
/* time_stamp */ '2024-04-11T21:25:57Z',
/* author */ (''),
/* organization */ (''),
show original
Also variation
One of the wedges cracked - the other 3 I printed are still OK.
I put this down to a “manufacturing defect”, by which I mean that when the 3D printer hit the pause layer, I didn’t get the captive nuts into the print within a reasonable time (it was many minutes later), so that under stress it delaminated at this layer.
[IMG_20250206_123914]
So, I’ve tidied up the design of my clamp wedge a bit and you’ll be able to find the STP file in the Router Be Gone thread.
The new one looks like this…
Acquista ricambi nuovi qui
People really like this new clamp to print. It is called a turtle clamp. It would replace the whole circle part.
Alle persone piace molto stampare questo nuovo morsetto. Si chiama “turtle clamp” (morsetto a tartaruga). Sostituirebbe l’intera parte circolare.
Why turtle clamp? Fresh off the printer, the cutout looks like a turtle to me:
[image]
Files here:
Intro
Stiffness of the clamps is something that I’ve been keen on improving for a while. I touched on it a bit as part of my I linear rails-ed my Maslow build. 20mm thick clamps seemed like an obvious place to start and gave me a significant improvement, but there was a lot more I wanted to do.
This is what I came up with:
[image]
There were a few points I wanted to address:
No split in…
