Print 3D pezzo di maslow 4.1 morsetti

[wouldchuck]

Here is the link. Nylon is good.

Ecco il link. Il nylon è ottimo.

Clamp%20Wedge.step

Also variation

Clamp Wedge Just Couldn't Take It No More

One of the wedges cracked - the other 3 I printed are still OK. I put this down to a “manufacturing defect”, by which I mean that when the 3D printer hit the pause layer, I didn’t get the captive nuts into the print within a reasonable time (it was many minutes later), so that under stress it delaminated at this layer. [IMG_20250206_123914] So, I’ve tidied up the design of my clamp wedge a bit and you’ll be able to find the STP file in the Router Be Gone thread. The new one looks like this…

Acquista ricambi nuovi qui
Here is a link to buy new ones that are nylon

Nylon Clamping Wedge

People really like this new clamp to print. It is called a turtle clamp. It would replace the whole circle part.

Alle persone piace molto stampare questo nuovo morsetto. Si chiama “turtle clamp” (morsetto a tartaruga). Sostituirebbe l’intera parte circolare.

Turtle Clamp (non-split clamp design)

Why turtle clamp? Fresh off the printer, the cutout looks like a turtle to me: [image] Files here: Intro Stiffness of the clamps is something that I’ve been keen on improving for a while. I touched on it a bit as part of my I linear rails-ed my Maslow build. 20mm thick clamps seemed like an obvious place to start and gave me a significant improvement, but there was a lot more I wanted to do. This is what I came up with: [image] There were a few points I wanted to address: No split in…