ntbee
July 5, 2024, 12:27am
4
As i found out, you dont need to remove the motor to fix the encoder board, you can pull out the bearing above the board to get access to solder the pin, see my post for pics
Don’t do what I did! Important note!
You dont actually have to extract the screws holding the motors on to do the soldering……
I basically wrecked all the holes in all the arms just trying to get the stripped Allen heads screws out, used plenty of thread locker of course, so after using, superglue, a Dremel with grinding stones and diamond bits, drill bits, extractors etc. etc I got one set out, then only to notice that you can just take a bearing out to get access to the board to make the sol…