The Big, Bad M4 Troubleshooting Problems/Solutions Thread

[gazinux]

To recover from ALARM trigger due to panic with message no heartbeat detected -

@ronlawrence3

You’ll then need to power down, power up, click “alarm” to reset, then in setup, release tesnsion, take the belts off, retract-all, extend all, then reconnect the belts to get back to where you can try again.

https://forums.maslowcnc.com/t/i-am-so-close-to-my-first-cut-but-need-some-help/21019/2?u=gazinux