Z diving problem?

[bar]

Fusion360 and G28 G-Code

Hello friends Not sure if others have experienced this and I don’t haven’t tried too many other products but this might be an issue with how Maslow handles G Code so I’ll ask about it: Fusion 360 adds a line in the G Code each time I post process a bit like this: G28 G91 Z0 This a kill the panel instruction basically as it plunges the bit right into the sheet and then, with router all the way down, returns to home. If the machine is already at home it will drop the bit and leave it down whil…

First Cuts and Lessons Learned......so far

Finally finished enough “around the house” projects to build a frame and get my Maslow put together. I was able to overcome each issue encountered through the forum posts, so thank you to the community for all of it. Assembly and Calibration: Had to up the current limit a bit to get consistent full retraction. This was the first thing I learned in the forums and I wished I had looked sooner as I partially disassemble the unit looking for issues first. Was very frustrated with the overall expe…

I’m not a fusion user so I’m not an expert, but these sound like the same issue, right?