Accidentally deleted preferences.json, and a question about anchor points [answered]

Any chance someone could post the preferences.json file? It’s not there, so I probably deleted it when I got the machine before I had the frame built.

Also, due to some bent spoil-board (and adding some 1x3’s below it), my anchor points are now below the top of the spoil board by 1/2 inch. Will I have to get a new spoil-board so this isn’t the case?

The calibration process failed a few times, and when it did work, it caused issues when I did a test cut. After looking it over, and checking some of the configuration files, these were the only issues I could find that I think would affect the calibration.

Welcome! Here is mine:

preferences.json (1.0 KB)

1 Like

Alex S wrote:

Also, due to some bent spoil-board (and adding some 1x3’s below it), my anchor points are now below the top of the spoil board by 1/2 inch. Will I have to get a new spoil-board so this isn’t the case?

try modifying the maslow.yaml file, look for the Maslow_*Z variables and add an
extra half inch to them (those variables are the distance from the ancor to each
arm)

David Lang

1 Like

Thanks! I’ll give those a try and see if it helps

1 Like