Yes, Thats correct. Extend all only extends enough belts to make it to the anchors based on the frame dimensions in the Config settings. So here is what you are going to do to extend them all the way-
Go into the Setup menu, and then go to the Config menu, and set the retraction force at like 100 and hit save. Then hit retract all, you may hear the motors start and stop, but you should soon see messages that all 4 belts have been retracted though they won’t actually move. Then hit extend all and pull them out till they stop. Then hit retract all, they shouldn’t move again. Then hit extend all and pull then out again and just continue that cycle until the belts are all the way out. After that, go back into Config and bump the retraction force back up to 1300ish or whatever you had it set to before. Hit save and then retract all. It should pull all of the belts back in and respool everything nice and neatly.
1 Like