Broken Maslow4 Clamp

After pulling the M4 apart several times I had a problem with Clamp breaking. Tried a repair with Epoxy putty but failed again. Have 3d Printed New clamp in a lovely pink colour (just what happened to be available) and it appears to be holding well. For information only, no action required.

2 Likes

I’d like to see a design in the not shop that leaves out all of the honeycomb in favour of a simple solid (with appropriate screw holes), then when printing you can just select your infill and go for it

2 Likes

Lee H wrote:

I’d like to see a design in the not shop that leaves out all of the honeycomb
in favour of a simple solid (with appropriate screw holes), then when printing
you can just select your infill and go for it

Here is a model in onshape that lets you adjust the spindle size and clip the
ears if you want.

It uses a m5 nut/bolt to tighten

I’d be happy to see a default version go into the not shop (see the thread about
adding things to the not shop)

David Lang

1 Like

Something like this?

M4_Clamp.wmv (2.5 MB)

M4_IA_Clamp.stl (9.8 MB)

1 Like

I forgot the onshape link doesn’t show an image

1 Like

Or this

M4_IA_Clamp.stl (8.4 MB)

1 Like