Calibrating Trouble

First time setting up the machine. Near the end of calibrating, when I do a test cut and then go to enter in the measurements I get the notification: “The machine was not able to be calibrated. Please ensure the work area dimensions are correct and try again.”

This is my third attempt to calibrate the machine, and each time the motors either stop randomly, or I get to the end and I get this error message.

Would love some help.

I haven’t had a similar issue when I’m calibrating. I used Web Control, and all the entries were in mm, so i had to do some quick conversions to get them in the right unit.

Which software and kit version are you using?