Can Easel automatically include Spindle Control (M4/M5) codes?

[Bob_Craig]

I’m using GroundControl today and hope to start using WebControl in a few weeks (when my RPi shows up). I’ve also got Spindle control (M4/M5) working. When calibrating, GroundControl automatically starts and stops the router, the router turns on and off as expected.

However, when I’m cutting designs made on Easel, it doesn’t include the Spindle control codes in the GCode. I’ve seen other posts suggesting to edit the GCode to add M4/M5 before loading into GC.

Is there any way to have Easel automatically add those Spindle control codes?

[Bob_Craig]

I think I found the answer and replied in this other thread on the subject.

Easel - turn router on/off

This is probably why - I hadn’t notice that setting before (I’m just learning) and had it set to Manual. When set to Automatic, it inserts M03 at the start and M05 at the end. [image]