Got the unit built, plugged in, lines retracted. (It pulled one at a time, had to hit retract 4 times). I found “Maslow” as a network the controller page displayed in my browser and I followed the instructions to upload firmware which SEEMED to load and then got this error (Multiple times)
Sorry to hear that.
Could you give us some details?
What firmware version did you try to upload?
I understand, the Maslow network still apoears, and you can connect to it? Just the web ui won’t load? Have you tried typing maslow.local in your browser address bar and connect to it like that?
I’m connecting according to the computer. Web UI (ESP3D for FluidNC) comes up and I can see the unit. I click the tab “FluidNC” then Click on the yellow update firmware button. I can see the files on the computer and I select “firmware.bin” and it Asks twice if I want to upload and the second time I press yes it gives me a Error :0 message with a red triangle (Different from yesterday)
Have you tried downloading the firmware again to make sure it isn’t a corrupted file?
Great idea. DLd the .7 and it uploaded 100% then immediately showed “Upload rejected not enough space”
Looked at the local Files and have
favicon.ico 1150
index.html.gz 157393
maslow.yaml 2116
Total: 192.00 KB | Used: 172.00 KB 89%
check that your system didn’t uncompress the index.html.gz, macs like to do that
for example.
the files must be named exactly the same as the files they are replacing, or you
get that error.
David Lang
Collins wrote:
so the Index.html.gz file goes into the maslow compressed?
Collins wrotewrote:
so the Index.html.gz file goes into the maslow compressed?
yes
