Fusion 360 Post Processor Maslow 4

Software
1

Is version 44104 the correct post processor to use for Maslow 4?

2

I would use the GRBL one. Maslow4 is based on FluicNC which is based on GRBL so anything GRBL should work great.

2 Likes
3

Ok perfect, I’ll probably just keep using the Carbide3d post then since that’s grbl as well.

1 Like
4

Aloha,

I have been using the Fusion Maslow post processor, but in this round the files aren’t working. So I gave the GRBL post a try and the files are MUCH smaller (yay!), but they seem not to know what WCS I’ve set in Fusion. Trying to get some cuts.

1 Like
5

Could not get the output from the Fusion Maslow post processor to work, so I switched to the Fusion GRBL and, after a kurfluffle regarding Work Coordinate System (WCS), it’s working well! And the GRBL post processor files are MUCH smaller already (like, 390K instead of 3M).

1 Like
6

Try this:

2 Likes