Fusion360 and G28 G-Code

[bar]

Yes! You aren’t the first person to encounter that, these guys seem to have found a solution:

Z Axis Plunging way to deep at beginning/end of cut

After breaking 2x ⅛ router bits I think I might have found another bug. Should have started with a test cut without a bit first… but I got overconfident after one successful cut. When I start a cut the z axis immediately plunges all the way down to the motors and then starts to travel to the starting point of the cut. At first I thought this was a mistake in my gcode as I have run into that before but I double checked all my CAM settings in fusion 360 and all looks good. Then I noticed this was…