i updated my new maslow just like it is said. to the new Fluisnc 4.xxx.
1 retract the lines
2 extend the lines
3 Calibrate ….
it starts retracting the lines takes about tree calibration point and then i t goes very wrong ..
The lower left line begins extinding even do the machine moves to the left.
it stops and begins calculating without stopping..
Please help
Hmmm that is strange.
Can you post a copy of the log file? You can copy and paste it here or use the save button to download it.
That should tell us a lot more about what is happening.
Maslow-serial (4).log (245 KB)
Fixed it… there problably was a corrupt file…uploaded firmware , maslowcnc.yml and index file from usbstick…and now it did a kompleet calibration..
Excellent! Great work figuring out what was going on 