M03 no longer starting router

I’ve been away for a while with other parts of life. Anyway, I need to do a Maslow project so I dragged out the machine from its corner (it’s on casters). I was running software and firmware 1.09 so I upgraded both to 1.19. I didn’t even try running it today with the old software and firmware but the M03 command (stored as macro 2) worked fine last time I had it out.

Now the Ground Control software shows that an M03 command is sent but there’s no output on the Aux1 terminals. Has this been moved to a different Aux or something? Anything else I can check?

1 Like

Can you try going back to 1.09 and testing it? Did you check the Advanced Settings? What is set for Spindle Automation?

Thank you

1 Like