Just had a perfect test run yesterday. tried to continue this morning, nothing.
the motors are not responding.
Groundcontrol works like everything is ok, the red curser follows the cut, but the machine is dead.
Power supply ok, the green light is on.
GC is connected, same port like yesterday.
What do I miss?
Hmmm first let’s just check out that everything is working properly mechanically. What happens when you press Actions -> Test Motors/Encoders?
Thanks for the quick response. Just was about to make up a heart warming story, but
I just found out I plugged in the wrong extension cord. I will have to find a better position for the arduino for better visibility.
4 Likes
That’s the best possible answer! 
Yay!
1 Like