Finally got my Maslow 4.1 up and running. Thought I’d share my setup and workspace in case it’s useful for others or gets some improvement ideas.
I have a dedicated workshop space. I’m planning to set up a work table so I can cut on the table instead of on the floor. For this, I made adjustable holders with slots — allows precise height adjustment. I also designed quick-release mounts that clamp with a single bolt — convenient and secure. Photos attached.
For the anchors, I made a special stop that makes measuring easier — works with both laser and regular tape measures. On one side I place the laser, on the other side it hits a special paddle/reflector. Very convenient for accurate measurements.
As you can see in the photo, a metal washer is embedded in the anchor - I inserted it during printing. This reinforces the bolt mounting point and prevents the plastic from deforming under load.
You nailed it with this idea! I was actually looking for a way to put my Maslow chair because the floor is tiled and I didn’t want to break the tiles. Thanks!
I’ll add a couple more photos and show how I made the mounting washer.
This is a trimmed washer with a nut pressed into it; there’s no need to weld it.
