Pops and drops when cutting horizontally

[Bee]

UniStrut Frame designs

Some minor improvements and initial calibration. First, some shots of the perfectly good chain guides, using the included Delrin roller, trimmed ~1/4" to fit 1.5" screws. The screw is kept loose enough for the roller to spin freely. [IMG_2377] [IMG_2376] Note: This position (mounted directly to the motor face) places enough pressure to keep chain on at least 180deg of the sprocket, and keeps the exit chain aligned entering the sprocket. This is important because as you’ll see I have the l…

@mrfugu’s solution is very useful. Thank you @Keith & @mrfugu

@bar and @dlang This will be helpful with the new Motor Mounts.

FYI - I will be putting a clear coat on my set. I suggest some kind of paint or they will rust eventually.

Thank you