Slight curve when cutting inside 2 inches from the top and the bottom of the sheet

[madgrizzle]

I’m working on the same problem. See this thread:

Chain Compensation Status

I’ve read through the forums a few times and am not sure what the status is of the chain compensation routine. It appears to be implemented, but I am not sure anyone is using it. I’m having difficulty getting my manual measurement of distance between motors to match that of Maslow and think this might be a solution (or getting new chains) but last I read on it, it’s still in “beta”. Is anyone using it and if so, what typical values are you seeing for left and right chain compensation? Thanks…