[SOVLED] Error 3 on startup

Troubleshooting
1

Every time I start the machine and load ESP3D I get the following readout. Any ideas?

Serial Messages
[MSG:INFO: Channel auto report interval set to 50 ms]
[GC:G0 G54 G17 G21 G90 G94 M5 M9 T0 F0 S0]
[GC:G0 G54 G17 G21 G90 G94 M5 M9 T0 F0 S0]
error:3
error:3
[MSG:INFO: Caution: Unlocked]
1 Like
2

That error 3 means that the machine is asking for for some data that isn’t in your Maslow.yaml file. Updating your maslow.yaml file should fix it.

If you have a good calibration you might want to write down your anchor point locations before replacing it so that they don’t get lost

3

Hmm, weird. I just uploaded the most recent yaml yesterday. I will try again. Calibration hasn’t gone well yet, but I will try again today and report back in one of the threads about that if it doesn’t pass muster.

1 Like
4

I had apparently failed to update the firmware at the same time.

1 Like