Starting cut from where it stopped when computer died

[aluminumwelder]

Can Ground Control be Paused and Resume Cut after Program Restart?

Can Ground Control be Paused and Resume Cut after Program Restart? For example, I had my laptop run out of battery in the middle of a project, and wanted to resume cutting after my computer had rebooted. Is this possible?

Way to resume cut after losing power and/or connection?

Hi, I’m wondering if anyone has found a way to resume their cuts after either a connection loss to the control board or losing power to the computer running the software? Unfortunately, I’m using a pretty low-end, old computer that has no charge left on the battery, so if I have any power surge, I lose power to my computer, router and control board. I’m OK dealing with this low-end tech I have, but have lost my cuts twice this weekend because I haven’t figured out a way to resume the cute aft…