Suggestion for the Store

[Stephen_Slagle]

@bar, I was just getting my order together for my Maslow, including the Z-Axis kit. I remembered seeing a post on how to measure the Z-Axis adjustment for my router, I did a quick search in the forums and located the instructions here:

Z-Axis - Measuring Shaft Coupler size?

Long time lurker, first time poster. I just put in my order for my maslow kit and am looking to add the Z-Axis kit as well. I have a Craftsman router (this one: https://goo.gl/3iEs4u). It is very similar to the recommended Rigid router, so I am going to give it a try. I’ve removed the adjusting knob exposing the shaft (picture below), but I’m not sure what size coupler to order. Measuring from flat side to flat side it is 1/4 inches, but curved side to curved side it is 5/16 inches. Anyone …

I was wondering if you could post this on the Store page so others wouldn’t have to search for it in the forums.
I know it is hard to believe, but there are those who have not read all the forum posts, and I only knew to search the forums because I saw it earlier.

I was also wondering if it would be possible to place out-of-stock bits in the cart so they could be included with the order during the next shipment in June/July…

Thanks
Steve

[jwolter]

@Stephen_Slagle

I know it is hard to believe, but there are those who have not read all the forum posts,

What? What’s wrong with them?

[bar]

Excellent suggestion @Stephen_Slagle, it is done

[Stephen_Slagle]

I know, Right!