Use a larger ring required settings

[madgrizzle]

@Neil_Jackson

If there is anyone who could assist me in understanding the settings/measurements needed when using a 300 mm ring. I have used approximately 34,75 mm as the distance from the roll edge of the ring to where the chain attaches

Look at this thread in the forum wiki:

Ring Kit Rotational Radius

I did another drawing that was to scale and then measured it. I get a rotational radius of 139.1 mm doing it this way. It can be off a very small amount based upon the diameter of the hairpin cotter pin. The diameters of the bearing is based upon @bar’s measurements from this post: [image]