This is my favorite corner mount design I’ve seen yet. Super solid, and I like that the frame itself is providing reinforcement for the entire mount.
When I printed this I noticed that the lag bolt would have been super close to the edge of my frame, and probably would have scarred the outside, if it grabbed at all.
I decided to move the corner hole in by 1cm, which seems like it would have worked well for the lag bolts I was going to use.
M4_AnchorMount-remix-1cm-offset.step (376.2 KB)
I also noticed this design wouldn’t work with the fancypins from the notshop, so I modified it further to shorten the height of the mount and add a lip for the pin to catch.
M4_AnchorMount-remix-1cm-offset-fancypin.step (370.9 KB)
I haven’t finished setting up my M4, so I don’t have any calibration numbers handy to see if shortening the size of the mount causes any issues. But overall I’m pretty happy with the result. I don’t have any experience with modeling, so this was a great learning experience for me. Thanks for the design @md8n