3D Printed Part

[TravisGood]

Months ago I printed this part but can’t find details about it.
Only yesterday was I reunited with my M4.1 and I’d like to install it.
Anybody know where this would have come from and how it’s to be installed?

[tryon]

That looks like my dust collection funnel experiment. Which is to try and get more of the sawdust out from under the sled, the second version of it is better. It is put in place after you attach a bit.

Enhanced Dust Collection Part

I have my Maslow hooked up to a dust collector and noticed that while it does a good job there can still be a fair amount of material that does not get sucked up. I figure this is due to the waste being thrown off at high speed into the underside of the upsweep of the sled where it can not be sucked up by the dust collection. I specifically mean this region that I have highlighted below: [image] To test this I modeled out a small part that would drop into the opening of the acrylic to force t…

dust%20funnel.stl

[TravisGood]

Super! Thank you … I’ll print your new versions.

[TravisGood]

It’s a beauty!

[ian_ab]

I like it, but it falls out in vertical orientation.