Cutting the Sled

[madgrizzle]

Yes, add tabs. There’s a forum wiki post on adding tabs:

How To: Tabs in Makercam

One of the most common problems that people run into when first entering into the CNC world is related to the creation of tabs. Since the Maslow is vertical, once you fully cut out a piece from your material, gravity takes over and it will fall or worse, get hung up in your sled. So, it’s common to add “tabs” to your project to prevent the piece from falling. These tabs are just small segments of uncut areas that hold the piece in place. After all cutting is done, you manually cut these tabs…