First Successful Run then Belt Jam

I was successful in creating my first thing. I went to release the tension and Maslow started paying out all of the belts. It caught me completely off guard and I was not successful in keeping up with all of the belts and one jammed. I took it all apart again and I am just about rebuilt again. Not a huge deal but less than ideal for sure.

I read that this issue was fixed in a newer release. I am using .87 to solve calibration issues. Can use the yaml file that I made with .87 on the newer release?

Or is there a way to safely release just a bit of tension? Maybe I clicked the release tension button too hard ;^)

Dave Waller wrote:

I read that this issue was fixed in a newer release. I am using .87 to solve calibration issues. Can use the yaml file that I made with .87 on the newer release?

@bar committed a fix for this earlier today, so it will be in next week’s
release.

you should be able to keep the same maslow.yaml file, and at the very least, you
can copy the anchor coordinates from the old file to the new file.

David Lang