GC cross hairs position doesn't match up with the sled position

[huntleybill]

I calibrated my Maslow and the cross hairs were lined up fine. I was playing with different things and practicing cutting stuff out on Styrofoam. For some reason, now the cross hairs in GC are farther up from center when the sled is at center. I have my sled dead center and the picture shows where the cross hairs are. Please don’t tell me I have to calibrate…again!!!

How do I get the cross hairs back into line with where the sled actually is?

[bar]

You do not need to calibrate again

Clicking Actions → Set Chain Lengths Automatic should get you back to center. It takes a couple steps but much less than the full calibration