Ground Control message continually toggles from "Connected" to "Not Connected"

[Bee]

please look over this thread -

Arduino Problem

SilasB, it may be other wires or interference. My suggestions; I would separate all the cables an inch or two including the motor/encoder cables if they are close (they are not twisted pair or shielded lines), Place chokes on all power and usb cable (or use a USB with a choke built in), My router was electronically the nosiest and got worse with a few hours of run time. So you may have been almost interfering when new, but over the limit with some router age. Don’t secure any cables close to …

Thank you