Also, something to consider, is Estlcam. You can try the fully functional software for quite a few cuts before it starts nagging you. And then, the total cost of the program is only $59. It’s quite similar as far as ease, to MakerCam. I use it, and after the first cut, I purchased it since it had me up and cutting in no time. Is it feature rich like Fusion360? No. Not even close. Can you learn it in minutes? Absolutely.
Set up a tool. Tell it what you wanna cut, where to put tabs, where the start point will be, and generate GRBL gcode and the maslow will pick it up and run with it. I’ve done about 10 successful 4x8 sheets with it, and have no intentions of continuing the search for cam software. I love that it goes from Sketchup to Cam to cut in mere minutes vs hours.
The only real gripe I have with it is, it needs an undo button. It might have it, but I sure haven’t been able to find it. lol