Must have router bits for maslow?

[gazinux]

No, not without some modifications. You need to add some dimension to the diameter and find a way to mount the PCB. Mine is Kobalt 1-1/4 HP Trim Router 7 AMP #5207238

Maslow 4 with Kobalt router

I have received my Maslow 4 in good order here in Toronto, Canada. I think I was order 200. No burst bags or PCB problems, just a little chip on the sled on the side where the dust collector plate will be installed. Assembly went fine, until I reached the part where you attach the electronics board support to the top of the router. This piece was specifically made for the Dewalt router so it does not fit the Kobalt. I am still debating what should I do with it. One option is to cut off the clam…

@dlang regarding the converter, you can always cut it down shorter. It still takes up Z range, about a half inch or so. To cut it you can place it in a drill press and spin then use a grinder with a cutting wheel to take care of business.