Need help with calibration

[madgrizzle]

Are you running the slack part of the chain along the top beam? That’s how most designs are done these days. Original design had the slack part of the chains running vertical down the side. If running along top, you have to select Chain Off Bottom… I suggest following makermade’s instructions on calibration. It applies to maslow no matter where you bought it from

https://www.google.com/url?sa=t&source=web&rct=j&url=https://www.makermadecnc.com/wp-content/uploads/2019/06/1.5CalibratingYourMaslow-3.pdf&ved=2ahUKEwjNivWR88_pAhWRl-AKHf8qB10QFjAEegQIARAC&usg=AOvVaw0HsGlpcqdvCoq94t5x_rQ2

Or you can follow the wiki

How To: Get Calibrated!

Note: The intent of this thread is to help people get their machines calibrated and answer “frequency asked questions” of the process. Do this First: Go to Settings->Advanced Settings and set the Extend Chain Distance based upon the following: If using a 10-foot top beam, set distance to 1651 mm If using a 12-foot top beam, set distance to 2032 mm The key to the setting is to make it a multiple of 63.5 mm and long enough so you can attach your chains to the sled when the time comes. Calibra…