Maslow Home Maslow Community Garden Newsletter

New Project Over Thinking Just a Tad

Hi Maslow forum; I have a Quandary. I am looking to piggy back the Maslow CNC onto a homemade planer/jointer/miller/driller/panel-cut-it-straightanator. I am planning to mount the slide on linear rail shaft (X,Y,& Z). So, I am looking to see if there is anyone who knows if, how, or where I can change the algorithms to direct (X,Y) movements in lieu of working against the hypotenuse?

Thanks to all for any help.

this would be a major rewrite of the firmware, just use grbl instead. It will be
a far better fit for your need.

David Lang

Why thanks seems quite a bit simpler.