Hi All,
At some point last year, I followed some directions (that I can no longer locate) to connect my PC to the M4 and correct its memory handling so that I could use v1+ firmware. I put the M4 away after that, took it out now and tried to connect to it. I am now getting the Fluid screen below. What do I need to do to now load the latest Maslow software on it?
Thanks in advance!
Paul
That is a lot of free storage 
I have never seen this screen before, I think it’s probably safest to just do the 1.0+ install again and start fresh. Here is the video you are looking for:
Thanks, Bar.
A weird thing happened. I rebooted it and it came back. I then updated to the latest firmware, and all seems right!
I’ll be getting it out and testing it on a new project this weekend.
