I popped the cover off my Ridgid 2200 hoping to see some pot switches. (Didn’t find this thread till AFTER, lol…isnt it always like that?!?)
Anyhoo, not sure if they’ve changed the settings, but i played w mine while powered on (don’t try this at home warning.)
and it’s already set to the lowest speed. (I reopened it after finding this thread and tried the settings, but for me, it just sped everything up.
Ah well, maybe time to look at spindles for some of my projects.
Be aware when removing the orange caP, there is a little two wire plug that’s glued to the orange cap. (I gently pulled it off (broke the glue bond) and re-inserted it. I initially though it was a safety that cuts the “go” circuit if the cap is removed, so i tested for shits & giggles…router will still RUN with it unplugged, so be aware its NOT a kill circuit. Also, if you don’t understand basic electrical, or have shaky hands, ! dont test it while plugged in as there are there is HOT bare tabs coming out of the control board that power the motor. 45volt minimum and goes up as speed dial goes up.
