Successful First Cut

[Carson_Barry]

15mm error while running code

So… confirmed. I downgraded with the following process: took down maslow from frame. Saved off my calibration numbers. uploaded 0.64 firmware, index.html.gz, and maslow.yaml (after entering my frame points) power off/on. verified Z machine zero looked reasonable (fluid tab, zm): it did NOT look right so I floored Z, powered off / on. saw that zm = 0, then moved z up and put in a bit. retract /extend / hang/ apply tension/ jog around. (see note 1 below). Tried @dlang 's manual calibration page …