Y axis won't move!

[jjdunes]

I installed new rollers and magnets yesterday, in my ongoing effort to eliminate the dreaded “Position error”.

Two of the original magnets fell out upon disassembly, and one roller was broken.
I put it back together and ran Find anchors successfully. Rms error was less than .5mm

But today when I set up for a job and ran Trace Boundary the sled just moved back and forth in X, and then I realized that it won’t move up and down at all. Jogging in Y does nothing (well, maybe a little grunt, but no movement).

I saved the log after find anchors. Should I send that?

Joe

[bar]

Hmmm that’s a new one! The first thing that comes to mind is that the machine has a work area bounds in the settings and the machine won’t move outside of that box. If the height of the box is set to 0 then I think it could end up acting like that.

[jjdunes]

Thanks! Somehow my Y Work Area got set to 1mm!

[jjdunes]

Here’s the aft seat for my dinghy (just cut, thank you), and the boat stitched up. Sides and bottom cut last week, transoms partly Maslow, partly manual.

[bar]

This is looking fantastic!