Z axis directional Issue keeps raising

Hey Community! I’m new to this machine. I have an auto z axis and the issue is the z axis keeps raising insead or lowering down to cut the surface. Much appreciated for any help given!

@imsc

Welcome to our group. What version of Ground Control & the Firmware are you on? What OS is in your connected computer? Are you using a bungie cord over the top of your router? What Router model are you using? Can you include pictures of your setup?

Thank you

Welcome!

Let’s figure out what is going on! Does the z-axis readout keep incrementing as it rotates?

What happens if you click the “define zero” button?

What happens when you run the “Test motors/encoders” button in Ground Control?

1 Like