Z axis zeroing with WebControl 0.94

[TimS]

Don’t worry about biting off more than you can chew. It’s not that bad.

Also search the forums for different z axis setups. Such as c-beam and meticulous z. The original ridgid setup had some part wear issues over time.

Checkout this quick add-on for z zeroing:

Auto z zero (aka touch plate) no macro needed as it is an option in webcontrol setting. Need cable, metal ruler and alligator clips.

Automating z-axis zeroing

You can automate the zeroing of the z-axis if you want to. It makes it a lot more precise and convenient. Solder pins on AUX4 on the motor shield. While you’ve got your soldering gear out, attach pins to aux1 as well, it can automatically start and stop the router. Never mind about the others, they aren’t used yet. Attach a wire (2m should be fine) to the AUX4 and one to the GND output Attach a piece of sheet metal, I like to use a ruler, to the AUX4 wire Attach a small metal clamp…

https://www.amazon.com/Pin-Sleeved-Fan-Cable-extension/dp/B006YZ7DJQ/ref=ya_od_pd_dx_gr_4?_encoding=UTF8&pd_rd_i=B006YZ7DJQ&pd_rd_r=c3a5a921-9a85-48db-93a7-c120b8b7318e&pd_rd_w=3SiqZ&pd_rd_wg=Iz1IJ&psc=1&refRID=JNP8NZHS580DC745N5ZJ