Maslow Home Maslow Community Garden

Compressed vertical axis


#1

Hey guys. I’ve finally gotten my maslow set up and doing my first few cuts, however I can’t seem to get the calibration correct. currently trying to cut the sled I’m losing around 4 inches on the verticle axis.

Its probably related, but trying to do the 5 calibration cuts, It will only move towards the corner without completing any cuts. Any advice?


#2

Can you expand upon this? What’s happening specifically?


#3

It would move to the top Left corner. then stop. Nothing else happens after it gets to the corner


#4

Is ‘Z-axis’ installed set to ‘on’ in the settings?