Hello from Costa Rica

[capicva]

Thanks @jwolter, it is indeed a big push. I am fluent in english, so I don’t feel behind a language barrier.

(My biggest worry is that as a hobbyist I have no technical knowledge and I’m definitely not an engineer.)

@Gero, I think @rossboss addressed the z-axis for this model in this post (I’ve been digging):

Shaft Coupler for Bosch 1617

[391] Remove the snap ring (70) from the shaft of the worm using a flat head. This is located on the under side of the housing. Be careful as snap rings tend to fly off and get lost. Un-thread the worm (44) until it is removed from the housing. Be careful as it threads through the locking pivot (45), which is only attached to the housing with a spring. At this point you should have the worm with adjustment knob (48, 44) free from the router body. to remove the adjustment knob, use a press…