of days on and off trying to get things to work. Thanks again and I’ll post what happens.
I followed the instructions and tried several times deleted and replaced arduino, Makerverse and firmware to make sure I was using the correct versions. Not working still
arduino compiles sketch uploads and says done with the the following message.
Sketch uses 62284 bytes (24%) of program storage space. Maximum is 253952 bytes.
Global variables use 2047 bytes (24%) of dynamic memory, leaving 6145 bytes for local variables. Maximum is 8192 bytes.
Makerverse still has pink box - Firmware: Required version: v51.28 Confirmed Protocol: Maslow
At Baud Rate: 57600
Response Protocol: Grbl v1.00
Firmware: MaslowClassic v1.28
I don’t know if any of this helps explain what is happening! I am using my tower with win 10 and will bring my laptop over to the shop after lunch and see if that changes anything.
Any advice help?