@Orob @custard @TimS I had to reprint my router clamp last night. I use @ShadyG’s router clamp under the Meticulous Z category (The Meticulous Z-Axis - #615 by ShadyG). I initially printed it in PETG, .28 layer height, 40% Cubic infill, .4 nozzle (The Meticulous Z-Axis - #707 by c00nphrog). I think over the last year and a half of use and the heat we had this summer, the PETG broke down, and the the infill percentage caused it to start failing. I reprinted last night in PLA+, .6 layer height (.8 nozzle), 70% Cubic infill (IIRC), 3 perimeter walls. Was estimated to take 7.5 hours, not sure how long it actually did as I started it and then went to bed. Woke up this morning and it was finished. Looked pretty good, and felt pretty strong. I’ll get it installed in the next couple of days. I am sure you can come up with one that will fit your size router.