GC shut down when opening a gcode file

[tinker]

@Fede19

WebControl and GroundControl are two different software packages that do the same thing.

If you do not have a groundcontrol.ini file from before then you just need to run calibration and it will create a new one.

GroundControl Calibration

How To: Get Calibrated!

Note: The intent of this thread is to help people get their machines calibrated and answer “frequency asked questions” of the process. Do this First: Go to Settings->Advanced Settings and set the Extend Chain Distance based upon the following: If using a 10-foot top beam, set distance to 1651 mm If using a 12-foot top beam, set distance to 2032 mm The key to the setting is to make it a multiple of 63.5 mm and long enough so you can attach your chains to the sled when the time comes. Calibra…

WebControl Calibration
On top menu select Help → Getting started
And start from “If you are starting anew:”